Case pro 700 isobus problems

[GPS_Support_2014]

Sadly the update doesn’t seem to have solved it, hopefully make some calls tomorrow to get help on it.
I don’t know if this settings page is correct, I’ve tried it on 6 and 12 soft keys, there’s versions 2,3&4 available, I’ve tried all 3. I’ve found an icon that says VT upload, with a (I’m guessing) loading bar under it, that’s not doing anything.
View attachment 857556

Most implements that I’ve worked with support version 3 so try leave it on that setting.

Do you have a photo of the implement vt screen loaded on the Valtra screen just to see if it’s one I recognise?

If you go to Diagnostics > VT > NVM you should see the object pools loaded from all implements that were connected to the display. You should see one for your amazon. Is there one there for RDS? If you read the small text it should be obvious for which implement it’s from.
If there is one from RDS try deleting it, switching off display, reconnecting implement and then switch on the display to see if it loads again.

Use this instruction as a guide:
https://www.agtron.com/_uploads/documents/DeletingPoolsFromCaseIHPro700_2016-10-20.pdf

 

[Matt77]

Thanks, got it sorted in the end, version 3 and 12 soft keys, and looks like I needed to unplug and re plug in after the screen reboot, which I hadn’t tried before, I was just changing the settings and letting the screen reboot.

 

[Liam cvx]

what year is the tractor? older CNH machines dont have the ignition pin in the isobús socket in the back. some implements need the ignition to start the ecu and some dont.

sorry to jump on to someone else’s thread. I’ve a 2009 plate cvx150 can’t get it to connect to NH square baler or anything via isobus. Although the screen does work with a different loom. Could this be because of ignition wire. If so is there anything that can be done

 

[osel]

Hello, I have a question. I have electronic remote-controlled valves, but I can't switch between valve actuators. In certain cases, I would like to have the remote one on the joystick and so on. Does anyone have any information about this? The dealer mechanic didn't have a clue. I would like to have this 2 menu-s like in the picutes bellow. I have pro 700 screen.

 

[Michael3112]

Hello, I have a question. I have electronic remote-controlled valves, but I can't switch between valve actuators. In certain cases, I would like to have the remote one on the joystick and so on. Does anyone have any information about this? The dealer mechanic didn't have a clue. I would like to have this 2 menu-s like in the picutes bellow. I have pro 700 screen. View attachment 1178164View attachment 1178165

You need to have the reconfigure tab on the hydraulics page, if its not there then the dealer would need to configure it on the laptop