How can one remove vinyl side writing stickers from vehicles?

[Pilatus]

As above.

 

[Netherfield]

We used a Hair dryer, to clear the ERF on the left

Heat gun, but now you've to be very careful not to damage the paint underneath.

In one episode of the Stobart programme on TV it showed them stripping the tractor units which are all white underneath, but I guess they had something set at the ideal temperature to melt the adhesive.

 

[Blue.]

Hair dryer.

Heat gun, but now you've to be very careful not to damage the paint underneath.

In one episode of the Stobart programme on TV it showed them stripping the tractor units which are all white underneath.

They must have got fed up,had 20 plus parked up next door bought by a dealer and they were still wrapped.

A nice warm day helps,wait till summers here.

 

[Netherfield]

They must have got fed up,had 20 plus parked up next door bought by a dealer and they were still wrapped.

A nice warm day helps,wait till summers here.

Perhaps the new owners aren't bothered now the name's disappearing.

 

[BuskhillFarm]

Heat gun/warm day, the tar and glue remover to get rid of the sticky left, then machine polish to get the covered and non covered paint work looking the same again, then a wax afterwards..

or just paint over the top of the stickers.. seen that done before too, they are the work of the devil to remove!

 

[Paddington]

My ex police Rangie had had the constabulary logos removed from the doors when I bought it but they still showed up under a certain light, never had to wait at junctions.

 

[e5c0rt.mk1]

Me and my brother took the stickers off his subaru a few years back. The stickers we pulled off without heating were hard to peel off but didn't leave any glue behind, the few we heated up came off easier but left the glue behind which was a nightmare to get off. He ended up getting the car painted as in certain places you could still see where they had been.

 

[quattro]

Just took stickers off a unit been on 12years easy job with hot air gun
just not too much heat

 

[norse]

wd40 will remove the glue after peeling the stickers off after using heat, spray it on, give it a couple of minutes and then rubs off.

 

[ARW]

Heat gun to remove then you can use brake cleaner, petrol or glue and tar remover for the glue
I put new bonnet stickers on this 2 years ago

 

[Edge Stickers]

Heat softens the adhesive. Take a look at this website there's lots of helpful advise on there https://edgestickers.co.uk/vinyl-stickers/

 

[Dry Rot]

Hot, but not boiling, water. Then clean up with WD40.