Has anyone had a new tractor on these tyres recently?
We got one on these and they're really strange looking the tread is very narrow just barely 600mm across but the sidewalls are bulged away out from the rim and the treads .
It was next to a 8 month old tractor at the dealer on the same...
Has anyone gone from a lexion to a Trion salesman tells me it's the same as a 750 lexion but when I asked an engineer he didn't have the same opinion.
Obviously the newer model 7500 is the replacement of a 750 but with more output but just wondering what a Trion is like.
Can someone educate me on what the square block is for on the floor drive of a spreader ? The holes go straight through but have valve type things screwed in from the sides .
Haa anyone actually shifted the tines position and what did it do for the overall job ?
Struggling to get it to clear everything in the overlap zones of the rotors .
This has likely been cover lots before but what's the best antenna to buy and fit to get DAB working ?
It's for a fastrac 4220 the antenna is crap to say the least and since the local radio station has changed due to my area stations are limited . I tried the DAB in the farm hilux and it picks...
We've got a spaldings/ true craft wheel trolley looks exactly thecsame as agri lonc ones and it's got very finicky as to the pedal position for releasing the wheel again .
Does anyone know where to source parts or a complete ram for these ?
Stubble cultivator points I'm losing whole tungsten tiles then they're just melting off .
We've got stones so are we'll used to chipping them off in pieces but this year I'm losing whole tiles.
First pic the point on the left is this year's done 60 acre half the top tile is still there but...
I've got some tight potentially seized track chain pins on my 8t would it be wise to throw a heap of oil at them to lube them up and give it a good run somewhere clean to try and free them off ?
Can someone help me with some settings?
My auto shut off has stopped working overnight it'll let me start a job etc but won't colour in the map at all
So can anyone help me with what these in the first pic should be set at I'm sure they weren't at 0 before
We got a new shaft for a machine direct from the manufacturer through our dealer.
Now I've noticed that there's no grease nipple on the centre piece of the wide angle joint just 1 on each yoke either side .
Is this normal now? it's the first time I've seen 1 like this we just got another new...
Anyone selling or know of a 14t + trailer
Requirements are long 20ft plus so it can take 2 grabful of muck long preferably air and oil brakes commercial axles with flotation tyres
So after 2 yrs after starting to think about building our new home and trying 4 sites I finally got to start levelling our site out this week.
The hole is 22m long x 12m wide
That's as much as I can get done just now I'll need to get back to farm work till the builder hopefully comes in...
We've been sowing rape with the sumo since 2012 putting seed in front of the roller and getting good results with it .
But last summer we got a lot of rain just after drilling and I think a combination of low seed rate and some being buried too deep in the light ground we had some patchy...
Things really have gone nuts now !!!.
Bluetooth to set a gas gun up :banghead: :banghead: :banghead: :banghead: :banghead: I picked up our newest gas gun from a hedge back and chucked it in the the gator drove 2 miles only to find out they're bluetooth now to set them . I mean really is...
Anyone point me in the right direction to get decorative metal pieces for welding into railings and gates. Like grain stalks and heads leaves and flowers etc
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.