Search results

We not guessing what tractor it’s for?

Aren’t these prices old?

Evening all Just wondering what a general purpose shed to store machinery be now? No panels just cladding to floor and one end open approx 60x30x14 I’m thinking kit form or erected TIA

Jcb 403

I’ll give this a go thanks

Just curious what people use to scrape back of cubicles and crossovers. We bed down with Envirobed but find it sticks to the bed if damp so the usual hand scraper doesn’t quite clean it unless you build up a sweat.

Does it need a strut halfway up tanker as a brace?

Jcb 403 for us. Does the scraping, bedding and clean out any tight calf pens etc. handy and agile machine. Just don’t steer full lock with a full dispenser halfway up or allow any cows being hoisted to pull perpendicular to machine 😂

Best post yet on this thread

You have a pic of how it’s mounted on the tanker?

I’m worrying about this also. A lot of farms are being advised (wales nvz) to cover their slurry stores and open yards before applying for increased capacity which in fact make the slurry thicker. We will be fecked off with this thicker slurry job whenever the splash plate ban will kick in.

Short chopped grass improves digestibility (D value) especially when grass has matured as cows can’t digest the wall stem of a sward so a chopper helps unlock that. If your harvesting grass at the stage where you’d would graze it then a wagon chop is fine as why would you chop it if cows graze...

And wagons are for harvesting the short high value grass that cows would graze. You’d be suprised as to how many people don’t understand this and start slagging off wagons.

What failure did you have on the tyres?

Thought I’d reprise this thread based on its title to save starting another thread. Considering retrofitting a turbofiller to my 6inch lazy arm as I speccd the arm to have a joint on it ready swap the end for a turbofiller. Is it worth it? Any thoughts/findings would be much appreciated. thanks

So what is wrong with the direct drives? I’m assuming unreliable?

Hi spec are straight axles on 2600 and above. Was told that the stepped axles were not rated to carry a full 2600 or above and a trailing shoe. But the tank sits closer to the straight axle so the height with it without stepped axle is the same.

Morning all. Got a 2010 640 where the Carraro front suspension has gone stiff to almost the point of not moving. When you turn it off and back on it does drop and pump back up fine. It’s also been greased. Any thoughts? thanks

Price was one. The 3000 hispec was a good bit longer and higher. I think hispec tankers above 2300 are now straight axle? The rain gun stone trap is easier to clean than the hispec also.

7 years old And looked after just as @ColinV6 looks after his tractors. Get it’s regular wash and annual polish and wax.